Create the look and feel of Concrete, Cast Iron, Cast Bronze, Terracotta and Limestone with Rust-Oleum Natural Effects spray paint. With a matt finish, the paint is lightly textured to replicate the feel of these natural materials.

  • Fast drying.
  • Tough, durable finish.
  • For use on most surfaces.
  • Interior and exterior use.

        The basics

        You’ll need

        • A well-ventilated area

        Colour Range

        Cast Bronze, Cast Iron, Concrete

        Availability

        Rust-Oleum Natural Effects Spray Paint is supplied in 400ml units.


        Gallery

         

         

         


        Instructions for use

        Why

        A premium quality, fast drying acrylic spray paint for use on most paintable surfaces, lightly textured to replicate the look and feel of cast iron, cast bronze and concrete.

        Prepare it

        Surfaces to be painted should be clean, dry and free from loose paint, rust, wax, oil and grease. Previously painted surfaces should be abraded to provide a key. Bare wood and metal should be primed with Rust-Oleum Surface Primer. Cover surrounding areas to protect from over spray.

        Apply It

        Shake can vigorously for 1 minute after mixing ball begins to rattle, continue to shake regularly during use. Hold can 30cm from surface and spray in a steady back and forth motion, slightly overlapping with each stroke. For best results whilst spraying keep the can the same distance from the surface and keep the can in motion. Apply several light coats a few minutes apart.

        Dry It

        Dry in 30 minutes. Allow 20 mins between coats. Drying times are based on warm (15°C), dry application conditions with good ventilation. Lower temperatures and higher humidity will prolong the drying times. 1-2 coats recommended.

        Cover It

        A 400ml can covers approximately 2.5m2 dependent upon surface profile / porosity.

        Clean It

        To clear spray for future use, turn can upside down and spray until clear gas is emitted.

         

        What else do I need to know?

        Limitations

        Do not use on galvanised steel or surfaces that regularly exceed temperatures over 90°C. Apply only when temperature is between 10-32°C and relative humidity below 85%. Special precautions should be taken during the surface preparation of pre 1960's paint surfaces over wood and metal as they may contain harmful lead. When dry-sanding avoid dust inhalation by wearing a suitable protective face mask. A copy of the appropriate Health & Safety Data Sheet should be consulted prior to using the product. For further information please contact our Technical Services Department.

        Store It

        3 years (unopened) from date of manufacture. (See base of can).

        Disposal and Safety information

        Please see the Material Safety Data Sheet.